Change rear sprocket, change chain?

S

slyman

Guest
Looking foryes/no answers:

If I change from the stock 44 tooth rear sprocket to a 41 tooth for better highway top speed, do I need to replace the stock chain? Vendor says "yes", I'm doubtful.

Thanks,

Slyman
 

Island Hopper

New member
imported post

imported post

You shouldn't have to replace the stock chain but depending on your adjustment range you will probably have to shorten it by a link or 2.

If your existing chain and sprockets show a lot of wear then you should think about replacing the works....
 
S

slyman

Guest
imported post

imported post

Since the stock chain has no master link how does one shorten the chain?

The bike only has 3000km on the odo so wear isn'ta problem.
 

Cedartree

New member
imported post

imported post

run with the stock chain. 3000 km should not have beat that chain too much, provided you haven't been abusing it and have been keeping it lubed.you will have enough adjustment to run a 41T rear, but you also will be pretty close to the end of your adjustment range.also be advised that you WILL be slipping the clutch more to get moving from a stop, and tight technical trails that require slow speeds will develop your left wristin a hurry.i bought a previously owned bike that came with a 15-41 gearing setup, and it was great for thehighway but lacked that nice lugging, useable low speed first gear. i now run a 14-44 or a 14-47 and only bolt on the 41 if i have some highway to cover. your stock chain will need to be broken if you choose to shorten it, this requires some careful grinding to remove one pin, and a master link kitto put it all back together again. HTH
 

Island Hopper

New member
imported post

imported post

You'll have to break the chain with a chain breaker or with a grinder carefully grind pin flare off of a link so you can push it out. Install the new sprocket and then put the chain on the sprockets to measure and then shorten it to the required length.

You can then install a clip type master link or have somebody with the proper tool install a rivet type link like the existing one.. The link should be of the same manufacturer and type as the chain.

Although rivet type links are more reliable, I have always run clip type links on my motorcycles and have never had a link fail, but I always carry a spare "just in case" link in my on board toolkit.
 
S

slyman

Guest
imported post

imported post

Excellent.

Thanks for the responses...:tup:
 
G

Guest

Guest
imported post

imported post

I have changed gearing on many bikes over the years, and if the chain was okay, just reused it, and never had a problem.



A dremel works prety well for grinding the link head off, and then a nail and hammer to drive the pin out.

Or do it right and buy a chain breaking kit. :hb:
 

Cedartree

New member
imported post

imported post

yes, Dave, i use two fingers therefore i am about twice as fast as you (at least until we get out for another ride and you stomp me again LOL i'm still dusty) but 1/5th the speed of a real typist...
 

ruskin

New member
imported post

imported post

I was experimenting with different gearing and using nearly new sprockets.I usedthe same chain andit was bagged in3000 kms.Once I found the gearing I liked, I bought a new chain and sprockets in that ratio and it's hardly stretched at all.It's said bysome that these components should be renewed as a set to guarantee long life.

A lot depends on your riding style,some guys can make their parts last longer than others.

Nick
 
Top