DR650 and the MSR skid plate...

TW_rider

Member
Just finished installing a new MSR skid plate to my 2010 DR650, and I thought I would give a "head's up" to anyone contemplating this modification.
The skid plate needs to sit a bit further BACK than it appears...here's why; the REAR mounting bolts protrude through the bracket nuts and if the plate is too far forward, the ends of the REAR mounting bolts will actually come into contact with the engine casing - not good!
However, there is an indentation/channel in the engine casing that runs from left to right (or right to left, depending on your point of view) and this channel is perfectly suited to accommodate those bolt-ends.
The nuts are pre-welded to the clamping brackets which REALLY makes it easier than I thought it would be; and the nuts are JAM nuts, so it will feel as though they are cross-threading as you tighten them, but they aren't...they're made that way! This is to prevent them from vibrating loose, although you DO check them before every ride anyway, right?:D

A quick way to check skid-plate alignment is to observe the oil drain-plug; it should be completely accessible when the plate is mounted. It may not be dead-center, but it should still be completely accessible. If not, chances are you are too far forward. Once you have the REAR mounting-bolt ends nestled safely in the channel, everything will be fine!

Also changed out the Counter Sprocket (only took about 20 mins) to a 14 tooth...MUCH better! I'm used to the trail gearing on my TW so the 15/42 on the DR was over-the-top for me! Even with the 14 tooth, I am still able to hit 140km/h on the highway with LOTS of throttle and RPM's to spare...maybe I'll go to a 45 tooth rear to really bring me closer to the trail gearing that I'm used to!
 
Top