DR650 Chain Play....

PistolPete

New member
Ok...I have put about 400km on the DR since I bought it a couple weeks ago. I was wondering if anyone could give me some insight into how much play should be in the drive chain. The manual says 1.2 to 1.8 inches. When I move the bottom of the chain upward it can touch the hard plastic guard, and appears to almost touch the top guard when released. I think I may hear the chain "slapping" the guard when I ride. It seems to "slap" only at certain engine loading....not coasting, not accelerating, somewhere in between.

Any ideas? I will more than likely have the bike into Richmond Motorsports sometime over the next couple weeks for new rubber and a good once over.

:hb:

Pete
 

Island Hopper

New member
imported post

imported post

Long travel bikes need quite a bit of chain slack, too tight and you risk having problems with your countershaft seals and bearings as well as rapid chain and sprocket wear. If your unsure how much slack is needed have somebody compress the suspension while you keep tabs on the tension as the swingarm moves through mid travel where the chain is at its tightest. The chain should not be zinging tight at this point a small bit of slack is OK. Hope this helps.
 

PistolPete

New member
imported post

imported post

Took a better look at things and researched a bit on TT. It looks like it is the chain rollers. I am gonna take them off tomorrow, grease them, and see how that goes. I will more than likely be ordering some aftermarket rollers as the stock ones are bushings and prone to noise.

Thanks for the responses...

Pete
 

Buck

Moderator
imported post

imported post

Greasing the stock rollers won't help. I got a set of bearing style chain rollers from Jesse Keintz of Keintz Engineering in Oregon. $13 each, problem solved... shipped by USPS, no border fees.

:hb:Mike DR650
 

PistolPete

New member
imported post

imported post

A squirt of lithium grease did quieten the slapping sound a fair bit. At least I know for sure that the rollers are the culprit, and a bit of grease will be good enough until I can get some bearing rollers.

Mike....how much for shipping from Jesse? I have been to his website and have seen nothing on international shipping charges. I looked into the ones from TT and the online store quoted $20 for shipping (no USPS option, only FEDEX). A bit ridiculous on $30 worth of parts.

Thanks..

Pete
 

Buck

Moderator
imported post

imported post


Jesse sends all parts by mail to Canada so it's only the price of regular postage depending on weight. I think it was a $3.50 stamp for the rollers direct to my mailbox, no other fees not even tax. Heavier items are held at the post office where you will pay a $5 handling fee plus both taxes. Still a deal compared to the UPS courier crooks!

Email or phone them for more info. Jesse and Janet are the best people for service and knowledge I've ever dealt with when purchasing over the internet. I buy most small items for my DR from them at about half or less of what it would cost up here.

Mike
 
Top