Fishing Rod on DR-Z 400

S

Steady

Guest
Do any of you have any slick / creative ways of carrying a fishing rod on a Suzuki DR-Z. I have been strapping it to the back seat (sticking out the back) but it is a bit vulnerable when going through cross ditches. My rod is about 40" long when broken in two....

Thx
 

skidmark43

Administrator / BFF in the blue jacket
Put it in a pvc rod case. The round ones are fine but if you can find one with a triangular profile they work better for this purpose.
Run the case along the right fork leg, HD foam for a set-off to get past the triple clamps. Strap with rubber-insulated strapping material & possibly bungies. Be certain that the case cannot slide further down the fork while in use!
Worked for me in the past & I have a similar setup on my mountain bike.
Check out Cabelas online for other ideas.

Mark
 

Wasp

New member
Hey DRZ riders. Just picked up a sweet one. But it is a bit too high. Any info on lowering. How much for a set of Kubalinks? what should be look out for? What would be a fair cost at a shop. One place quoted 300.00 including labour to lower in balance...still seems a bit high to me? Thoughts? the seat is already as low as it can go... corbin..1 1/2 inch. Will do the shocks.

Also we are looking for a larger tank, windscreen and a rack????? anyone???
 
IMG-20110525-00045.jpg

Hi wasp;
There are lots of ways to mount a fishing rod on your DR-Z but you're going to have to change your gearing if you want to do any trolling. Haha!


Attached is an image of how I carry mine - much the same as the way skidmark described although mine's on a DR650. I leave the tube on all the time. It never gets in the way and for the most part, it blends in well enough that I don't even notice it there. It kind of dorks it up a bit but who cares?



One thing to be aware of is that while you're riding, the rod will be banging against the bottom of the tube and the little bit of foam in there just doesn't keep the rod end from fracturing. I put a real thick piece of high-density foam down there and now the lid is hard to close. But once it's screwed on and closed, the rod is nice and snug and doesn't move at all.


On a smaller bike I once had I was able to put a two piece rod into a pvc tube and I strapped that to the left side of the bike. I used nylon straps and the tube angled downwards from the left rear signal light to the downtube in front of the engine. I strapped it to the frame above the left foot peg and to the frame near the left turn signal. This worked fine on a thinner bike but on the DR650, it's already wide so a configuration like that is in the way of the left knee too much. Also at that time, I had enough money for a bike OR a nice pack rod, not both.


The pack rod on the front fork is definitely the better way to mount a rod but the most important thing is just to get a fishing rod mounted on the bike so it's useful!

Wayne
 
Top