Blown clutch on DRZ400

paintingpeter

New member
I had another great training session out at Triangle Beach. Slow maneuvers through the sand for balance and clutch/throttle control. I just ended up with no clutch by the end of it. Need to replace the friction plates this week. Hopefully they're in locally.
 

Shuswap

Member
How many KM on that bike/clutch? The DRZ isn't known to be a clutch-eatin' machine. Oil type can apparently play a role also.
 

tomcycle

Past President DSBC 2004 -2018
Staff member
unusual story, i put countless clutch slipping kms on two drzs never did anything to the clutches, cant speak for those who bought the bikes after me.
 

paintingpeter

New member
I have 13,800 km on it. I think the last batch was 10-30 weight, so I'm going to stick with 10-40 (specifically 4 stroke). When I took the clutch apart, the outer friction plates were pretty worn. I've ordered a new kit through Holeshot. Not cheap, but I need the bike back pronto.
 

tomcycle

Past President DSBC 2004 -2018
Staff member
DO NOT USE CAR OIL make sure the oil you buy is manufactured for wet clutches, typically motorcycle oil. Those high mileage car oils are too slippery for wet clutches. Probably just need the fiber plates if the steels are still flat. But its best to change it all. Like I said earlier, I used my clutch for 1/2 gears all the time, sometimes those long hills you dont need second gear or first gear but 1.5. never had a problem. I am bigger than most riders out there too.

T
 

Shuswap

Member
.....what Tom said....... but that's short life for a DRZ. Might want to consider dropping a tooth on the countershaft sprocket if you do a lot of slow riding and not-so-much highway cruisin.
 
Last edited:
Top