Dr 650 lowering front end

RoscoeP

New member
Has anyone here lowered there DR650. When I got mine the rear end was lowered but not the front. I put it back to stock. I am putting Eibach springs on it this year front and back, and would like to lower it.Does anyone know the proper way to lower the front(not raise the forks in the clamps)I heard something about changing a part inside the forks? Anyone know? Cheers Roscoe:hb:
 

joker650

Active member
imported post

imported post

There is a spacer in the forks on the lower section......it gets moved to a different spot. I'll see if the procedure is in the manual, scan it and post it.
 

joker650

Active member
imported post

imported post

CRAP !! Who stole my manual!! :mad3:







;) can't find it , need a cpl days
 

Buck

Moderator
imported post

imported post

I just slid the forks up 1 1/2", just short of the bars.. That way its easy to slide back down when 17" supermoto wheels are mounted.
 

joker650

Active member
imported post

imported post

00Buck wrote:
I just slid the forks up 1 1/2", just short of the bars.. That way its easy to slide back down when 17" supermoto wheels are mounted.
I would also do it this way. The only thing different by doing the internal parts swap is the time it takes to do it.
 
R

Randy and Dee

Guest
imported post

imported post

slide them,it only changes the stering angle very slight.You will hardly notice .My wifes is lowered front and back and has no trouble.Also I think you need a spicial tool to get one of the bolts out of the shock ???
 

Buck

Moderator
imported post

imported post

No special tools, a metric socket, I forget which one. Support the bike on a stand. Will need a shorter sidestand or cut and weld yours as I did.
 

RoscoeP

New member
imported post

imported post

Thanks everyone for the info.I have a short side stand so no problem there. I'll wait until I get the springs from Jesse then do it. Cheers Ross
 
Top