Factory DR350 tank - I haz a question

motorambler

New member
I am temporarily going to be using the factory DR350 tank while I wait for a couple new Acerbis petcocks/gaskets, etc for my big tank. Anyways, I noticed the factory petcock has 2 nipple connectors: a large brass one & a smaller steel one below it. I am guessing the larger one goes to the carby, but what about the other one? I have a service manual somewheres but I can't track it down at the moment due to my recent move.

dr350_fuel_lines.jpg
 

DS Dude

New member
imported post

imported post

Should be a hose on the other side of the carb about 2/3 the way up the side nearer the motor or a port for the hose to go on to
 

mint400

New member
imported post

imported post

I concur... I bet it's on the carb (I'm no mechanic)... best buy the aftermarket service manual... vac is used to actuate the petcock flow in the on position...
 
O

old trials guy

Guest
imported post

imported post

I thought the factory petcock relies on crankcase vacuum? Regardless, you canset iton the prime position which is a mechanical on position that requires no vacuum to operate. It just doesn't automatically turn off in this position when you turn off the engine and there is no more vacuum.

otg
 

Cedartree

New member
imported post

imported post

Vacuum petcock on that bike uses intake manifold vacuum taken from a port either on the carb orsomewhere between the carb and head. The crankcase is vented so there should be no vacuum there as you would see on a two-stroke.
 

motorambler

New member
imported post

imported post

Sorry for not updating this thread: yes, there's supposed to be ahose that runs from the petcock to the other side of the carby.

Ifound out yesterday thatmy new petcocks/gaskets are waiting for me in Blaine, so it looks like e factory tank is not gonna be installed after all...
 
Top