I'am just getting around to some mods on my bike and to getting rid of the "death wings" I got the tires (MT-21's) changed over and was putting the front wheel on. The book says to torque the front axle then tighten the top pinch bolts first then torque the bottom pair. So if you do this there is only a space on the bottom half of the clamp correct? or should there be a small gap top and bottom.:?
It's also a bit akward trying to line up the rotor, hold the speedo cable in place and make sure the spacer dosn't fall out, any tricks to make this easy? Cheers :hb:
It's also a bit akward trying to line up the rotor, hold the speedo cable in place and make sure the spacer dosn't fall out, any tricks to make this easy? Cheers :hb: