imported post
imported post
A bit of a pain to remove the carb on a 640, but here goes: first remove vent tube from frame above carb and move it out of way, next unscrew top cap {2 screws} and carefully remove diaphram/slide assembly, next loosen manifold clamps so carb can rotate, remove throttle cable mounting plate {2 screws} angle screwdriver works or rotate carb a bit to get at heads then once loose you can remove the two cable end toggles from the rotating cam, next remove choke/enricher by loosening collar nut with a 12mm open end wrench{ a little tight for working in but doable} once loose the cable piston assembly should slide out and can be carefully moved out of the way {keep good track the the little piston and spring so it doesn't fly off upon removal}, next remove the two vent tubes off the upper right side of carb, next remove throttle position sensor {2 screws} and note its position for reassembly, remove fuel supply line, next rotate carb so you can get at the float bowl screws from the manifold side, remove idle thumbscrew, remove floatbowl {2 screws} and carefully pull down and remove float cage keeping track of the needle, unscrew the main jet so it doesn't hang up. Now the carb should be small enough to pop out of the manifold and rotate up between the frame rails. Clean out the jets and passage ways with spraycan carb cleaner and air, stubborn clogs can be removed with fine wire . Popping on decel usually means a lean condition, check to see if your slide diaphram is not torn {do before carb removal just in case},make sure your slide needle is set near the middle clip position. Also your pilot jet could be partially clogged or if equipped with a fuel pump make sure your vacuum line from the pump to the manifold is not leaking. Also check for exhaust leaks. Also if you've done any airbox/muffler mods without jetting changes this could cause a lean condition. Reassemble in reverse order and be carefull not to bump the float tang out of adjustment as proper floatheight is a very important part for 640 carb tuning. Told you it was a pain, good luck...