MityVac brake bleeding help

klrman

New member
Bleed my front KLR brakes just fine with MityVac, but everytime I open up the nipple
in the rear, air gushes in. Any good tips how to stop this?

Another thing I was wondering was, how long does it take to bleed the air out of the front cable if it needs to be replaced and can I do it with MityVac? Last year I replaced my cable with a braded one and then of course no pressure at all, and pumping the brake lever did nothing, so I drove it to the local shop last year and they fixed it as did not have MityVac back then . But now I need to tackle another bike and am a little aprehensive if MityVac is the way or is there an easier way to try and flush all the air out of a new cable once installed? The reason I am asking is that
the MityVac still seems so slow, but maybe that is how it goes as I don't know so much about bleeding properly.
 

Island Hopper

New member
imported post

imported post

Why are you bleeding the brakes? Did you do a fluid change? If air is sucked into the nipple when you crack it try taking your resevoir cap off to release the vacuum.

I'm assuming mityvac is some kind of vacuum pump, if this is the case you should be able to hook it to your bleeder nipple crack the screw and vacuum out the air bubbles while making sure the resevoir does not run low and add new air to the system.

Good luck.....
David..
 

klrman

New member
imported post

imported post

Was bleeding them as they felt a little mushy. I did all that and it worked
great infront. The rear was another story. Oh well, have a bigger problem anyway now...my motor smells really bad, I wonder if I burnt a valve or something as I adjusted my brothers valves but not mine yet.....I really hope that smell is comming from the fuel stabilizer I had in there all Winter:shock:
 

RoscoeP

New member
imported post

imported post

There is a coating made that you can put on the threads of the bleed nipples or use teflon tape. This will help prevent air from entering past the threads. I usually spread grease around the base of the nipple with a Q-tip and this will stop air from entering.
Also make sure you keep the reservoir filled as you bleed or air will enter from the top.
You could buy speed nipples which have a spring loaded ball bearing, but you still can get air coming past the threads. They coat the threads with a coating to prevent this. It may have to be reapplied every year or so as it wears off. They also sell tubes of it.
Hope this helps. Cheers RoscoeP:hb:
 

klrman

New member
imported post

imported post

Thanks RoscoeP, that worked nicely. I did not have any grease lying around
so I used some Vaseline and it did the trick!
 

klrman

New member
imported post

imported post

Sure did and the next thing on my Winter list is to put teflon around the nipple
threads to make things even simpler.:hb:
 
Top