New Rotor and Pads Question

P

PoCoKLRDriver

Guest
I just installed a new EBC 320 mm rotor (with the caliper extender) with Galfer green pads on my KLR 650. Everything fits properly, however the wheel does not spin freely in the caliper. There is even resistance through the whole rotation. Is this normal or are the pads somehow too tight? Thanks in advance.
 

joker650

Active member
imported post

imported post

Hm.......this sounds familiar.

I think someone else posted the same question here.

Not sure what the out come was.

See if I can find the thread.



Nope...didn't find it.
 

Yak_KLR650

New member
imported post

imported post

Last time I put pads on the KLR, I didn't depress the piston far enough and they dragged. I took them off, reset the piston more fully and they fit fine.
 
imported post

imported post

I installed the same thing on my KLR last summer. I did have to push the piston way back in and there was still a bit of light drag at first. Took it for a short ride and stopped several times to check the rotor temps. It didn't get very hot so it seemed to settle in quite quickly. Easily by the time I was just 15-20 minutes into the ride the drag was completely gone.

Hope this helps
 
P

PoCoKLRDriver

Guest
imported post

imported post

Thanks for the replies. I figured the pads would be snug with the new rotor, but I just wanted a second opinion. I just took it out for a short 15 km ride and all is well.
 
K

KLR Kid

Guest
imported post

imported post

I did have a similar problem with the rear brake pads binding on the rotor after I had the rear wheel off for service. As Scotty mentioned, it turned out to be a piston issue...it had partially depressed inward and was binding...only slightly on the rear rotor. If it improves in the very near future as far as new pad wear goes I think you will be fine...obviously you need to stop frequently to check for over heating and brake fade in the interim.

I was thinking about a bigger front rotor on the way home from work today...when a cager just about put me into the centre median of the Pat Bay Highway......when it comes to brakes...size matters. Look forward to hearing if the rotor change has made a noticeable difference on your bike.

Rob:hb:
 

masonjarz

New member
imported post

imported post

What about a review of the bigger disc?

I am thinking of doing the same mod--was it worth it? Did you do SS brake lines at the same time (or have them before)?
 
imported post

imported post

The big rotor does make a significant difference in the KLR's braking performance, though maybe not quite as much as you expect. I found that it brought the braking up to what it should have been if it had been properly designed. In other words you come up to average braking performance for a non-KLR. Given how poor the KLR normally is this is a big improvement. :hb:

I didn't do the SS brake line upgrade, nor upgraded pads (though I did install new ones).

Would I do the upgrade again on another KLR? Absolutely! Even though it isn't an eye-popping experience at least you should be able to stay out of the trunk of the cage in front of you. :hr:
 
P

PoCoKLRDriver

Guest
imported post

imported post

Ditto to Backcountryboy's review. The difference is significant but not huge. Definitely shorter stopping distances, and less of that feeling that you're going run out of brake. I'm also finding that the progression from soft to hard braking smoother. BTW, I don't have the SS lines either, though I did put Galfer green pads on (don't know if that's considered an upgrade or not).

I would definitely do the mod again if I had another KLR (considering how poor the stock brakes are). A little costly (near $300 when all is said done), but these are your brakes we're talking about. Hope that helps anyone considering it.
 
Top