o'ring chain oil ?

claw

New member
imported post

imported post

how do you apply kerosene to the chain ? pour it on or wipe with a cloth.ive never heard of kerosene on a chain.
 

Island Hopper

New member
imported post

imported post

I usually soak some on a rag and hold it around the chain and spin the wheel... In effect wiping the chain clean... It's not good to submerge the chain in the solvent as it may dilute and flush out the sealed in grease.....
 

Buck

Moderator
imported post

imported post

Buythe four liter jug of kerosene from CDN tire, pour some in a pan, place under chain to catch drips. Use rubber gloves, borrow your wifes new ones under the kitchen sink.Soak a facecloth, then wipe the chain and sprockets clean while spinning rear wheel by hand. If really dirty, use a soft bristle brush,such asyour wifes newnail brush. Do not use a wire brush as the bristles could slip between side plates to damage o-rings. Afterward, wipe down theswingarm and other greasy areas. Wash off all residue with hot soapy water,wipe dry with a soft terry towel, the pink fluffy one in the linen closet works nice.. then lube with your favorite chain oil.Keep the chain on loose side of specs and it will rarely need adjustment. Finally, take your wife for a ride to calm her down. After using this method, I sold a street bike ('02 FZ1) with 50,000 km on the original chain and sprockets, still in good condition.
 

JetDog

New member
imported post

imported post

00Buck wrote:
Buythe four liter jug of kerosene from CDN tire, pour some in a pan, place under chain to catch drips. Use rubber gloves, borrow your wifes new ones under the kitchen sink.Soak a facecloth, then wipe the chain and sprockets clean while spinning rear wheel by hand. If really dirty, use a soft bristle brush,such asyour wifes newnail brush. Do not use a wire brush as the bristles could slip between side plates to damage o-rings. Afterward, wipe down theswingarm and other greasy areas. Wash off all residue with hot soapy water,wipe dry with a soft terry towel, the pink fluffy one in the linen closet works nice.. then lube with your favorite chain oil.Keep the chain on loose side of specs and it will rarely need adjustment. Finally, take your wife for a ride to calm her down. After useing this method, I sold a street bike with 50,000 km on the original chain and sprockets, still in good condition.
Wow, 50,000K - crazy. Thanks for the info. I guess the only remaining question is whether I shouldwheel the bike into the living room to do this or if I should just skip that stage and do it right in the doghouse...
 

BMWNut

Member
imported post

imported post

At the shop we've had the two extremes of chain maintenance roll in.

One rider came in complaining that the bike was making a strange noise when rolling along. The chain was a horror story. Never lubed in it's life, never cleaned, never adjusted. It had severe kinks, tight spots, and was a rusty mess. New chain and sprockets needed at 7,000KM.

Another customer, ex-bicycle racer who was anal about chain maintenance, came in. Cleaned chain with WD-40, ragged off, and lubed very regularly. The chain/sprockets had over 20,000KM on them and all you could say is that they weren't brand new.

As far as chains go I guess you could say the more maintenance you perform the less maintenance you will need to perform. :)
 

Randaroo

Member
imported post

imported post

so....I take from this that a factory original chain on a KLR should get 22000 befor replacement? Mine is loaping and kinking, making a real racket all of a sudden. It stretched yesterday like pulled toffee, the adjustment to get home was quite significant.

I'm assuming the original chains are junk(2007)what isthe good replacementchain?

Should I assume if the chain is junk the sprokets will be too? Replacement sprokets every time the junk chain gets changed?
 

Buck

Moderator
imported post

imported post

Ona dualsport the front sprocket wears about twice as fast as the rear. General ruleseems to bereplace the frontevery 10k,then both sprockets and chain about every 20k, depending on wear and maintenance.
 

Island Hopper

New member
imported post

imported post

The original KLR chains are made by EK and are pretty good quality.... My original KLR chain gave me 17,000 KM which I thought was good service life when you consider the amount of gravel and dirt I rode on.... The chains usually require frequent adjustment when they are on their final days....

DID X-Ring chains have worked best for me.... The current one I am running has over 16,000 KM on it and has not needed any adjustment yet....
 
Top