PistolPete
New member
Rear rack is going to be here next week, chain rollers are on their way, new rear rubber today.
While I was at Richmond Motorsports I inquired as to what would have to be done to revert the 2000 DR back to stock height. I bought it off of a guy who bought it right from a Suzuki Dealer with the ride height already lowered. The service guytook a quick look and said that they would just have to swap out thelonger "Dogbone" (cushion rod) with a stock one. He looked at the front and said it had not been lowered.
I have a DR650se service manual and it has a section on how to lower the ride height. The method it describes has nothing to do with the "Dogbone". It says to lower the ride height the rear spring seat is flipped and a couple extra parts are needed (they are called PLATE and PLUG in the manual). The manual describes the relocation of a spacer with the front fork to change the height of the front (not visible without disassembly).
Basically is there any surefire way to know what has been done to the bike previously, so that I can make sure that RMS knows how to put it back to stock?
Would anyone be able to measure the length of their stock unloaded (fully extended)front fork, and the tip to tip length of a stock "Dogbone"?
Thanks...
Pete
While I was at Richmond Motorsports I inquired as to what would have to be done to revert the 2000 DR back to stock height. I bought it off of a guy who bought it right from a Suzuki Dealer with the ride height already lowered. The service guytook a quick look and said that they would just have to swap out thelonger "Dogbone" (cushion rod) with a stock one. He looked at the front and said it had not been lowered.
I have a DR650se service manual and it has a section on how to lower the ride height. The method it describes has nothing to do with the "Dogbone". It says to lower the ride height the rear spring seat is flipped and a couple extra parts are needed (they are called PLATE and PLUG in the manual). The manual describes the relocation of a spacer with the front fork to change the height of the front (not visible without disassembly).
Basically is there any surefire way to know what has been done to the bike previously, so that I can make sure that RMS knows how to put it back to stock?
Would anyone be able to measure the length of their stock unloaded (fully extended)front fork, and the tip to tip length of a stock "Dogbone"?
Thanks...
Pete