Returning the DR to stock height

PistolPete

New member
Rear rack is going to be here next week, chain rollers are on their way, new rear rubber today.

While I was at Richmond Motorsports I inquired as to what would have to be done to revert the 2000 DR back to stock height. I bought it off of a guy who bought it right from a Suzuki Dealer with the ride height already lowered. The service guytook a quick look and said that they would just have to swap out thelonger "Dogbone" (cushion rod) with a stock one. He looked at the front and said it had not been lowered.

I have a DR650se service manual and it has a section on how to lower the ride height. The method it describes has nothing to do with the "Dogbone". It says to lower the ride height the rear spring seat is flipped and a couple extra parts are needed (they are called PLATE and PLUG in the manual). The manual describes the relocation of a spacer with the front fork to change the height of the front (not visible without disassembly).

Basically is there any surefire way to know what has been done to the bike previously, so that I can make sure that RMS knows how to put it back to stock?

Would anyone be able to measure the length of their stock unloaded (fully extended)front fork, and the tip to tip length of a stock "Dogbone"?

Thanks...

Pete
 

RoscoeP

New member
imported post

imported post

When I got my 04 this year it was lowered,shorter sidestand etc. Looks like the only thing that was done was to change the rear shock to the upper hole. Didn't look like they changed the spacer in there at all. I just moved it to the longer setting and put on the long sidestand.
I know they are supposed to do something in the front forks and flip the spacer in the rear shock as well. Cheers:hb:
 

PistolPete

New member
imported post

imported post

Well, as many of you already know, Jesse Keintz is a god and an absolutely fantastic guy to deal with. I have (so far) only ordered a set of chain rollers off of him, but I sent him an email yesterday outlining my situation. Here is the response I got.

Hi Peter, You are correct the dog bones have nothing to do with the lowering of the rear. You just move the bottom shock bolt down to the lower hole in the clevis and flip the spring retainer so it seats lower on the clevis on the bottom of the shock. This will raise the bike back up to normal height in the rear. The front should have the forks even with the top triple clamp. If it seems still lower in the front you could check inside the fork by removing the cap and see if the steel spacer is still in there on top of the spring. If not then it is under the damper piston and the forks will have to be removed and disassembled to bring it back to the upper height. Prior to removing the fork cap, be sure to first unload the forks and loosen the top triple clamp bolt then loosen the cap.


Talk about a great guy....can't thank him enough for the concise and quick response. It makes me wonder about the guys at the shop that looked at my bike???

Hope someone else can make use of this info also.

Pete

PS...TT forum info...stock dogbone is apprx 114mm from center of bolt hole to center of bolt hole. Measured mine to be the same.
 

RoscoeP

New member
imported post

imported post

I will give them all my business if they have what I am looking for. Just bought a FMF Q pipe from them and had a chat with Jesse on the phone about jetting. Got the pipe in one week and they don't burn you for shipping like some places.
He sent me a free #165 jet because that size does not come in a jet kit.
Nice to meet someone that will take the time to talk to his customers. I hear nothing but good comments about him on all the DR web sites.
Cheers :hb:
 
Top