sidestand and clutch cutoff switch?

RoscoeP

New member
Just wondering if anybody disconected the electric switch on there sidestand and clutch. If you did, what is the way to go about it. If I did it I would like to be able to put back if I ever sell or start to forget to put the stand up. Cheers :hb:
 

joker650

Active member
imported post

imported post

If U do not lubricate the sidestand pivot point the switch will not cause u any problems:ted:

My dr650 has had many hard dirt miles on it and the only time I had problems with it was after I lubed it.The stand would bounce down after doing a jump and the ignition would shut off:mad3:

As for the clutch switch.... it will give you no problems and will prevent any 'accidents'



Personaly I like having the both of switchs working.:tup:
 

Buck

Moderator
imported post

imported post

Same here. I left the safety switches connected. Prevents dumb accidents when you are overtired. For me, thats most of the time!
 

tomcycle

Past President DSBC 2004 -2018
Staff member
imported post

imported post

I must be "old school"

first thing I always remove from my bikes is the clutch and sidestand switch, then carefully put them in a box to give to the next owner (that never seems to happen and I am now accumulating these things).

On the DRZ400, just follow the wires up the frame to under the seat. You will find a plug, cut the wires on the switch side of the plug and connect the two wires, remove the switch and save in a safe place.Done.
 

joker650

Active member
imported post

imported post

tomcycle wrote:
I must be "old school"

first thing I always remove from my bikes is the clutch and sidestand switch, then carefully put them in a box to give to the next owner (that never seems to happen and I am now accumulating these things).

On the DRZ400, just follow the wires up the frame to under the seat. You will find a plug, cut the wires on the switch side of the plug and connect the two wires, remove the switch and save in a safe place.Done.
Then get a big drill bit and drill out the exhaust.:Dhehehe
 
R

Rawperformance

Guest
imported post

imported post

I shortened the spring set to increase the tension on the side stand and lube the pivot regularly.
 
Top