Starting 92 DR 650

meteor59

New member
I sold my 84 XT600 and bought a 92 DR650 which I am about to put on the road after working on it .The only problem is I don't know the starting procedures for the bike since I didn't get an owners manual,can anyone help me on this. I know it ran fine I just don't know the tricks.

Thanks
 

ktmken

New member
imported post

imported post

Using the compression release (handle on the handlebars) slowly kick the kickstarter over until you are just past top dead centre on the compression stroke....Do not use any throttle!! Use choke when it is cold, no choke when it is warm. Let go of the compression release and give it a good solid kick. Not a wimpy kick , but a good" I am a 250 pound solid hunk of man" kick.
This was the drill for the 91 Suzuki 650 that I used to ride, and it would start 1st or 2nd kick everytime.
 

tomcycle

Past President DSBC 2004 -2018
Staff member
imported post

imported post

The real secret is "don't touch the throttle" no matter how much you think it might help:wi:. Twist the throttle and you canadd another half dozen kicks to the starting procedure.

If you do happen to have a lapse in judgement and give the throttle a twists by accident, take your time, you don't have to do those manly kicks just gentle kicks (the bike will not start on the fist 6) then get ready for the starting kick:ted:and do it like you mean it.

Previous owner of 91 DR650

TT
 

meteor59

New member
imported post

imported post

Hi

Thanks for the info ,I have been busy and have got back to it .Some fresher gas (funny my lawnmower ran on it) and the proper procedure and it started after a few kicks.Thanks.
 

bigfabber

New member
imported post

imported post

I have an 86 DR600 which I ride daily. After awhile you will likely find you don't even need the decomp lever. It is actually really easy to find TDC once you're used to it. I find it helps to remind myself that this is nothing like an electric start bike and to manage my expectations. Occasionally my bike makes me wait a bit to get going, but she never strands me, ever.
 
S

SBG

Guest
imported post

imported post

These techniques are close, but the EXACT way is to pull in the decompression lever. Then SLOWLY go through the kick stroke till the decomp lever pops out. This is TDC. NOW is when you can give it a good kick.

If it doesn't start, repeat ALL the steps.

I've gone to cycle shops that don't even know how to start it afterI walked them through it. They think it's just like every other bike with a decomp lever. It's not. This was one of suzukis best ideas, and it seems that over half the owners never figured it out. However, the instruction manual is clear, and those with issues never read it. After taking mine out from winter storage, and cleaning off the cobwebs, it's usually a 1 or 2 kick (cycle) deal.
 
C

CrunchyProd

Guest
imported post

imported post

I have an '86 DR600s. Like has been said above. When cold, pull the choke out. When warm, don't touch it. Usually goes on 1st or 2nd kick. Didn't know about the compression lever and letting it pop out. (I'll have to try that).

Only time I've had a hell of a kick is when I stall it when it's been really hot. Seems to take a few extra kicks.
 
S

SBG

Guest
imported post

imported post

I just want to state that mine is a 1990 DR650S, US model.
 

Attachments

  • newboots11011051724.jpg
    newboots11011051724.jpg
    76.8 KB · Views: 0

pittiepride

New member
imported post

imported post

So I guess the correct procedure is NOT to try and start it with the decomp lever? I have a 92 DR 650 that I just bought and I'm about ready to push this POS off of a cliff!! I'd ride it off of one but it just won't start. :mad3:


This bike is new to me, and all I can say is man.... what were the japanese thinking? Why wouldn't you put an electric start on these bikes? At 6 ft and 175 pounds I can kick this fool machine over til I'm blue in the face, and eventually get it started, once warm it still takes 8 or so kicks to get going again. Runs fine once it runs, a little boggy in the lower RPM's but pulls like a bat outa hell. I've owned a 78 Yamaha TT500 and I thought it was hard to start, but it doesn't hold a candle to the DR! :wi:


My starting procedure:
Cold, pull choke.. pull decomp lever, kick repeatedly. I've had several people tell me to try kicking it without the decomp lever, and I've tried a few times but had no luck. What am I doing wrong?
 

tomcycle

Past President DSBC 2004 -2018
Staff member
imported post

imported post

Just asking here and want to make sure your are using the decomp lever correctly

Pull the decompression lever until it clicks into place

turn the engine over with the kickstarter slowly until the decompression lever clicks out, you are now the compresstion stroke

now bring the kickstart lever to the top and give the old girl a long stroked kick

DO NOT TOUCH THE TROTTLE:mad3:In fact I use to hold the center of the bars to make sure I did not give the gas a little twist

My old DR started first kick every time (unless I fell over or stalled the bike)

[line]



This same proceedure can be accomplished without the decompression lever, you just have to turn the engine over until you on the compression stroke. EZ to feel because when you begin the compression stroke it will be real hard to rotate the engine

TT
 
S

SBG

Guest
imported post

imported post

You only pull the decomp lever in, you do NOT hold it. It will pop out on its own AFTER you kick SLOWLY the first time. You let the decomp lever POP out and stop the slow kick at that point. This is TDC, NOW you kick it hard.

Use the choke.
 
G

Guest

Guest
imported post

imported post

tomcycle wrote:
Just asking here and want to make sure your are using the decomp lever correctly

Pull the decompression lever until it clicks into place

turn the engine over with the kickstarter slowly until the decompression lever clicks out, you are now the compresstion stroke

now bring the kickstart lever to the top and give the old girl a long stroked kick

DO NOT TOUCH THE TROTTLE:mad3:In fact I use to hold the center of the bars to make sure I did not give the gas a little twist

My old DR started first kick every time (unless I fell over or stalled the bike)

[line]



This same proceedure can be accomplished without the decompression lever, you just have to turn the engine over until you on the compression stroke. EZ to feel because when you begin the compression stroke it will be real hard to rotate the engine

TT

I own a 91, Toms got it on the money.

For an easy cold start, I Prime the cylinder holding the decomp open and throttle openfor 3-4 mild kicks,release androtate the kick untill the lever Snaps,return the kick starter to the top, pull 1/2 choke and it fires easy every time.! If you have to jump on it like an Ape..your doin it wrong.:ted:and you'll bugger up your kick gears
 
G

Guest

Guest
imported post

imported post

Oh ya... Keep an eye on the decomp cable..it stretches or fraysand can be out of adjustment. That will cause problems starting an old DR. If you rotate the kick you'll find that every second kick the kick starter is higher and has a longer stroke than the first. find the long stroke and it will start first time. never use the throttle. Only to primeitfor a cold start. The decomp mechanism gets freekin hot andthe wee cable gets brittle and dry.Ive changed mine twice in five years.($23) and new NGK's:clap:help.!

Hey Meteor59 or any member that wants..I have an owners maual on my hard drive.shop manuals are gold for the 90-92 Dr's..It's not much but has some stuff you might not know.

PM me with your email and i'll bounce back what I have. Feel free to ask question.

cheers:hb:
 

pittiepride

New member
imported post

imported post

Thanks to all of you for the info, it's too late to try it tonight (it backfired earlier and just about deafened my wife) but I'll be out early tomorrow to see if she'll start for me. Even though it has pink writing, it's still a mean lookin machine. Anyone have a link for some updated DR decals? Thanks again :hb:



Ken
 

pittiepride

New member
imported post

imported post

Well we've tried all suggestions and to no avail with starting. This bike does not like me and it's gotta go.

I'll be taking it in for a mechanical inspection to determine if there is anything wrong with the bike and it is now up for sale and hopefully I can get what I paid for the thing. I'll enjoy my 2000 e-start dr 650 from now on!

Ken
 

tomcycle

Past President DSBC 2004 -2018
Staff member
imported post

imported post

Get the truck out, tie a rope to the tripletree, drop the dr into 3rd and drag it along till it starts, get the wife to drive:hr:and make sure she doesnt drag you down the road
 

pittiepride

New member
imported post

imported post

Ken just called me from the cell on his way home from Van with the new dr and we have one last thing to try which sounds absolutely stupid, but apparently the 2000 dr has to have the clutch in even in neutral to start (it is e-start) but we wonder if this would be so for the 92 as well...we'll see tonight when he gets home.

We don't have a lot of expereince with different bikes so we feel like it's just gotta be something stupid we don't know about...anyone in the Courtenay area want to come for a boo that would be awesome, give her a try and I'll give you a great deal to take her home!

kara (and ken)
 

Attachments

  • bike2.JPG
    bike2.JPG
    16.1 KB · Views: 0
Top