Sticky Steering

PistolPete

New member
2000 DR 650 22000km

I think I might have the problem figured, but wanted to get a 2nd opinion. It seems like the handlebars want to steer straight. Up on the stand the bars turn freely, but out on the road it seem like there is a "notch" where the bike want to go straight. It takes a little more than normal effort to turn off of center, then everything is fine. I think it is the bearings in the head tube...more than likely a pitted race where the bearings have been repeatedlypounded against the race.

Whaddya think? Anyone else had this happen?

Pete
 

tomcycle

Past President DSBC 2004 -2018
Staff member
imported post

imported post

Yup that sounds like steering head bearing, if nothing else is rubbing

TT
 

sagot

Member
imported post

imported post

Yep lower race most likely. Replace all of them and don't over tighten. Then adjust after 300 km or so.
 

PistolPete

New member
imported post

imported post

Got my father looking through his stock in Edmonton tomorrow. He might have the steering bearings along with front, rear, and cush bearings. Might as well do them all at the same time!
 

PistolPete

New member
imported post

imported post

Replaced the steering bearings today. Not that bad of a repair. The hardest part was getting the bottom bearing off of the steering shaft. I ended up CAREFULLY grinding down the bearing until it cracked due to the pressure fit on the shaft. Then I was able to wiggle it off with some WD40 and a pair of channel locks. A bearing puller would have made the job easier! Steering is butter smooth now. I am gonna make this a yearly service....pull the steering shaft and relube the bearings.

For anyone with a DR....The steering head bearings are an NTN part. NTN part number is 4T-CR-0643L.
 
Top