imported post
imported post
I am a hd mechanic and have always done my own bike work.
The valve set is basic but.....there is not verry much room in there and I find it hard to get the proper setting. Maybe my feeler gauge set is too big, and the square adjuster seemed hard to get rotated into the proper position with a wrench. I think SUZUKI sells the proper tool for this and that would make it way easier. Yeah just looking at the picture in the manual there is a screwdriver type socket that they are using. I think I will order that tool.
Feeler gauge P/N 09900-20803
Adjuster driverP/N 09917-14910
Those P/n's are out of the 1999 DR650 factory service manual. Prety sure everything is the same on the 2001.
Engine cold
exhaust: 0.017-0.022mm(0.007-0.009in)
Intake: 0.08-0,13mm(0.003-0.005in)
Good luck:tup: