Valves and a DR 650 (2001)

Payback

New member
My bike is almost at 12000km, I see in my manual I should adjust my valves.......Is there much too it?? I haven't done a lot of mechanical work on my bike ,but I really want to learn! Can somebody help me out! thanks
 

joker650

Active member
imported post

imported post

I am a hd mechanic and have always done my own bike work.

The valve set is basic but.....there is not verry much room in there and I find it hard to get the proper setting. Maybe my feeler gauge set is too big, and the square adjuster seemed hard to get rotated into the proper position with a wrench. I think SUZUKI sells the proper tool for this and that would make it way easier. Yeah just looking at the picture in the manual there is a screwdriver type socket that they are using. I think I will order that tool.

Feeler gauge P/N 09900-20803

Adjuster driverP/N 09917-14910

Those P/n's are out of the 1999 DR650 factory service manual. Prety sure everything is the same on the 2001.







Engine cold

exhaust: 0.017-0.022mm(0.007-0.009in)

Intake: 0.08-0,13mm(0.003-0.005in)





Good luck:tup:
 

Buck

Moderator
imported post

imported post

A bent feeler guage helps but you are right about the special tool making it easier. Also available from Jesse at Keitech.com. Great guy and a DR expert.
 
Top